I have trouble to implement CLA in my program, this is the situation : -> My project is working correctly on flash in standalone mode with all periphericals which I need (ADC, PWM, CAN, GPIO, Timer, ...

Customer is trying to put a small application run by R5f in the 2MB SRAM shown below. We think the execution speed is the same as the corresponding clock for the SRAM. Could you help to check if this ...

We have a requirement to protect the power line against induced voltage from the tailgate motors, which we control through H-Bridge IPDs. Our idea is to use LM74700 + NMOS, but connecting CATHODE to ...

In MMWAVE MCUPLUS SDK User Guide (4.5.0.2) 4.4. How to run mmWave demo with LVDS-based instrumentation 1. The AM273x LVDS interface is a TX only interface intended to pass raw radar ADC samples to off ...

I've tried for some time now to use the TLV320ADC3140 with the Raspberry Pi using the Linux Kernel driver. I am using the ADC3140EVM-PDK evaluation module (https ...

We have a project on lithium iron phosphate; After being fully charged, the SOC is 100%, and when placed, it will automatically drop to around 90%; How can I avoid not falling down? I also tried to ...

Thank you for your notes. I have revised the design to include a DC path for the V+ inputs. Additionally, I have set the recommended passive values according to the datasheet. However, I have noticed ...

We are using ChemID 6121 obtained by GPCCHEM. And battery termination uses ⊿V and ⊿T, so FC Set % is -1. When we looked into the E2E site, we found that there was a similar problem below. Even though ...

ThetaJC(top) JESD51-14 No board. Dierct connection with a heat sink or thermal grease is used between a DUT and a heat sink. ThetaJB JESD51-8 JESD51-7 High-k board PsiJT JESD51-2A JESD51-7 High-k ...

When accessing the resource explorer through the Getting Started page in Code Composer Studio, I am getting the HTTP 403 Forbidden error. It seems that my network is ...

I am trying to use TMS320F28335 chip to drive permanent magnet synchronous motor. I use the ECAP module of TMS320F28335 chip to capture the rotor position of the motor, and use the open-loop FOC ...

Hi all (and Tony Cave, I hope you are the same TC listed in the app credits and as support in the Google Store), I have the same exact issue as reported in: https ...