Product added to your wishlist! View wishlist
Sign in to see your saved products on any device
Product removed from your wishlist! View wishlist
Sign in to see your saved products on any device
Something went wrong. Please try again later.
Product is added to compare already. Please refresh the page.
Product is not found in compare. Please refresh the page.
5 Products already added. Please delete existing selection to add this.
Share this product
Mortise Lock Single Point Lock Active 60MM - Marvin Caradco Jeldwen Doors
This product ad may change over time
ShareMortise Lock Single Point Lock Active 60MM - Marvin Caradco Jeldwen Doors
Single point active lock (SPL) for Marvin Ultimate and other inswing doorsmanufactured 1/17/2000 to present.Lock Body Type: American cylinderHandle spacing: 3-5/8 inch (92 mm) Center of handle to center of cylinderBackset: 2-3/8 inch (60 mm) Measured from door edge to center of handleBackset without Face plate (measures 2-5/16 as shown i…
Single point active lock (SPL) for Marvin Ultimate and other inswing doorsmanufactured 1/17/2000 to present.Lock Body Type: American cylinderHandle spacing: 3-5/8 inch (92 mm) Center of handle to center of cylinderBackset: 2-3/8 inch (60 mm) Measured from door edge to center of handleBackset without Face plate (measures 2-5/16 as shown in 2nd image)Deadbolt throw: 1 inch (25.4 mm) TaperedPatent NO. 6,209,931Single point locks used by Marvin, Caradco, Jeldwen and othersPriced and sold each.NOTE: Does Not include faceplate or Strike, lock body onlyScrew between Latch and Deadbolt is a # 6 Flat head, not includedChange Handing:1. Insert screw driver into slot behind latch2. Pull down on handing release, latch pops out3. Rotate latch and push back into lock caseALWAYS Check Function of lock before closing doorOperation:1. Lift handle to engage2. Turn Thumbturn or key to extend deadbolt
Description
Single point active lock (SPL) for Marvin Ultimate and other inswing doorsmanufactured 1/17/2000 to present.Lock Body Type: American cylinderHandle spacing: 3-5/8 inch (92 mm) Center of handle to center of cylinderBackset: 2-3/8 inch (60 mm) Measured from door edge to center of handleBackset without Face plate (measures 2-5/16 as shown in 2nd image)Deadbolt throw: 1 inch (25.4 mm) TaperedPatent NO. 6,209,931Single point locks used by Marvin, Caradco, Jeldwen and othersPriced and sold each.NOTE: Does Not include faceplate or Strike, lock body onlyScrew between Latch and Deadbolt is a # 6 Flat head, not includedChange Handing:1. Insert screw driver into slot behind latch2. Pull down on handing release, latch pops out3. Rotate latch and push back into lock caseALWAYS Check Function of lock before closing doorOperation:1. Lift handle to engage2. Turn Thumbturn or key to extend deadbolt