Easy to install. Good quality. Well packaged. Worked as expected. I would purchase again.

After trying several motion detectors this one finally worked with my led wall pack.

The WAC Lighting Endurance White Motion Sensor is fast to respond and reliable. The WAC was mounted in place of the “hole plug” in a LEONLITE 2-head light, which was intended for a third LED (see pic showing WAC mounted to LEONLITE). The LEONLITE ON-Time was set to maximum, which enables the WAC to control the ON-time. The WAC was wired to apply/cut all power to LEONLITE. You must be experienced with electrical wiring to make this modification inside the LEONLITE. The WAC could be mounted separately from the LEONLITE, which could be done with less experience in electrical wiring.\n\nThe IR motion detector of LEONLITE was slow to respond and malfunctions when it rains, as have six similar cheap IR detectors, with symptoms such as stuck on, flashing, no motion detection, etc. As an electrical engineer, I measured the LEONLITE adjustable resistors used to set ON-Time, Sensitivity (Range), and LUX and found they measured near 400kOhms. It is well known to electrical engineers that impedances above 100kOhms are unreliable due to uncertainty in surface leakage resistance. While the LEONLITE IP65 rating purports to keep water out, it is not hermetically sealed, thus humidity inside can easily condense on the uncoated motion detector PC board causing malfunctions, which explains why many cheap IR detectors are erratic.\n\nThe WAC with IP66 rating solves these problems for reliable operation. Yes that costs 2X, but you get what you pay for.

It works. Settings were a bit finicky, and the whole assembly feels a little plasticky and cheap, but it works. Glad to find one in grey.

Installed it last week. Works well. Range is around 21' with the sensor mounted 12' high. Good instructions, and which explicitly allow for parallel control of lights from another switch (e.g. with smart switch placed in electrical box). It has extreme versatility with dealing with odd orientations of the knockouts in your electrical box/cover. The stem bends at 2 points, and can rotate around the long axis of the tube between those two knuckles as well. If that isn't enough, the kit comes with extension tube and connectors to increase the degrees of freedom for orientation and displacement.

Works great and was very easy to connect replacing an older one.